Molds and UV Resin

Create cute and fun pins or pendants using Martha Stewart Molds, Glitter and UV Resin!

Supplies:
UV Resin
UV Light
Martha Stewart Molds
Fine Glitter
Pin Backs or Bails
E6000 Glue

Begin by pouring a thin layer of resin into the mold, place under the UV light for a few minutes and then do another thin layer but this time add the glitter! But under the UV light for a few more minutes and complete by giving it one more layer of resin. After you have let it sit under the UV light, pop it out of the mold. Sometimes when it pops out of the mold, the front looks a little foggy. If this happens, don't fear! Just use a brush and brush on a THIN layer of resin on the foggy area and it will shine right up! Add your pin back or bail (to make a pendant) using E6000 glue.