Ideas and Inspirations

                                      Mummy Wreath

14” Straw Wreath

7/8” White satin ribbon

10” White Deco Mesh

Black Paper

40 mm googly eyes

Scissors

Hot glue gun

Greening pins

Wrap the straw wreath with the satin ribbon, hot glue at the end to hold in place

Pin in the end of the deco mesh of the right of the top of the wreath. Twist, turn to go to the other side and pin. Repeat until the wreath is total covered.

.

Take a 17” piece of deco mesh, at both ends cut in the middle. Where you cut take the ends & tie in to a knot. Do the same on the other side.

Pin the piece in right under the knot on one side of the wreath. Pull to the other side and pin in.

Take your black paper. Draw your mouth and oval shaped eyes and cut them out 

Hot glue the top & bottom of the mouth to the deco mesh (put the deco mesh on the top of the paper) leaving the middle exposed.

Hot glue the google eyes onto the oval pieces and then to the deco mesh (putting the deco mesh on top of the paper) leaving the most of all the eyes exposed.

You can add firefly lights to the mummy!

                    Joy @ Hilo Ben Franklin